Brass Connector Pin For IEC EV Charging Plug
Contact Pins For Sae EV Charging Plug
Charging Pin Connector For GB/T EV Charging Plug
NACS Connector Pin For Tesla EV Charging Plug
Lamella Contact Pins
Hyperboloid Contacts
Crown Spring Pins
Energy Storage Socket Connector
Energy Storage Plug Connector
SS1 Series Connector for Energy Storage Connector
SS2 Series Connector for Energy Storage Connector
Custom Cable Harness Assembling
Wiring Harness Connector
EN50620 Cables
Electric Vehicle Charging Cable
Elevator & Conveyor Cable
Industrial Cables And Wires
AC Charging Connector
DC Charging Connector
Type 2 Open End Charging Cable
Type 2 -Type 2 Charging cable
CHAdeMo Connector
GB/T DC Charging Connector
NACS Vehicle Plug
Mode 2 GBT Portable EV Charger
J1772 SAE Type 1 Portable EV Charger
IEC62196 Type 2 Portable EV Charger
DC EV Charger
AC Socket Cable(AC Socket→Battery)
PDU Cable(Battery→Motor)
Motor Wire
PTC Cable(Battery→Air Conditioner)
DC Socket Cable(DC Socket→Battery)
Ground Wire
Three Phase Power Line
Air Pump Line→Compressor
The electronic locks developed and produced by AUPINS are mainly used in national standard AC charging sockets on new energy vehicles and national standard pile charging sockets. During the product development process, technical points such as the size of the electronic lock actuator, dual-position signal feedback for locking/unlocking, and overall ≥IP66 protection performance were fully considered. The current advanced clutch unlocking method for manual unlocking ensures unlocking reliability and other technical points are overcome and solved. Problems and concerns customers encounter when using electronic locks.
Conform to the provisions and requirements of GB/T18487.1-2015
Use ultrasonic welding process, with small size and beautiful appearance
Have a signal feedback function and manual emergency unlocking function.
Special internal waterproof protection performance, protection grade achieved IP66
Reliable material, flame retardant, pressure resistance, abrasion resistance, impact resistance, and high oil resistance.
1. Mechanical properties:
Drive time: 500ms (12V.dc, normal temperature)
Lock rod push and pull force: ≥35N (12V.dc, normal temperature)
Life span: 60000 cycles (12V.dc, normal temperature, power-on time 500ms, interval 3s)
Cable specifications: FLRY-B 0.5 square (insulation outer diameter φ1.5mm~φ1.6mm)
2. Environmental performance:
Working temperature:-40℃~85℃
Protection level: ≥IP66
3. Electrical performance:
Rated voltage: 12V.dc
Working voltage: 9V.dc~16V.dc
Rated current: ≤1A;
signal switch current: ≤0.1A
Locked rotor current: ≤2.5A
Insulation resistance: 500V.dc, 1min
insulation resistance: ≥100MΩ
Withstand voltage performance: 500V.ac, 1min
leakage current: ≤10mA
